Step 1:
Select Open Jobs.
Step 2:
Select the open job you wish to perform an inspection within.
Step 3:
Select the camera icon to scan an asset barcode.
The camera will open ready for an asset barcode to be scanned.
Step 4:
Scan the asset barcode.
A list of checklists will pop up.
Step 5:
Select the appropriate checklist.
The first checkpoint will appear on the screen.
Step 6:
Select either Pass Check, Fail Check or Not Applicable.
You are able to add an image as evidence, however, adding a picture is not required.
You are also able to add notes regarding your findings, again, adding a note is note required.
Step 7:
Select Proceed to move on to the next checkpoint.
Move through every checkpoint.
As you are moving through the inspection you will notice the % of completion increasing in the top left-hand corner.
When you select Proceed after the last checkpoint within the checklist, you will be taken to the end of the inspection and the inspection will be 100% complete.
Step 8:
Submit & Close Off the inspection.
You are able to leave comments if you wish to.
If your inspection is successfully submitted, the following message will pop up.
When the Inspections show 0/1, it means the inspection is still syncing.
Once the Inspections show 1/1, it means the inspection sync is complete.
When you click into the Inspections, all of the inspections within the job will be listed.
The green check indicates that the inspection is complete, has been submitted and the inspection sync is complete.
If you go back to your Open Jobs screen, you will see that there will now be an orange clock icon, indicating that the job is in progress.
You have now successfully performed an inspection!